My Fair Lady Ballgown, Part VII: Tiara

 

81ed1f03a7469f1506b4a81e3d699f4b

For one of the accessories for this outfit I had to find an appropriate small tiara. It was actually harder than it sounds– while there are tiaras galore on eBay, most are much larger than the delicate piece Eliza Doolittle wears in her gigantic updo. The few smaller ones weren’t much better– they were usually too rounded and none had the tiny dangles you can see in the original. I finally came to the conclusion that I’d need to cobble one together myself. Luckily, after much searching I found this comb, which had the radiating tines decorated with rhinestones, even if it was in the wrong color. I removed the heart from the front and snipped off the extra tines so there were only seven, just like the movie version. I had to bend them into the correct position to make them look like they were radiating from a wider base, as well.

embassy-comb-before embassy-tiara-after

Continue reading

Advertisements

Queen of Hearts Costume, Part VI: Finished!

I’m finally done with my Queen of Hearts costume! Here’s what it looks like with all of the pieces put together:

q-of-hearts-full

And here are the links to each step:

Part I: Design and Fabric

Part II: Tailoring the Underdress

Part III: Neck Ruffle

Part IV: Hearts and Overskirt

Part V: Sleeves

Next up, the making of the Mad Hatter and Cheshire Cat costumes!

Queen of Hearts Costume, Part V: Sleeves

Once the main dress was done, I made a set of detached sleeve-puff thingies to wear on my arms. I bought some black satin and stitched it in stripes with the extra red satin from the back side of the shawl. Once I had two long striped pieces, I cut out some equally long but much narrower pieces of red cotton and attached them to the striped sections as a lining.

q-hearts-sleeve-stripe

The inner layer being narrower than the outer layer allowed the striped layer to puff out a bit along the vertical axis. Then I sewed narrow channels into the top and bottom edges and ran elastic through them, which gathered the sleeves horizontally into nice puffs that would stay up on my arms. I did have to stuff the puffs with fabric scraps to give them body– otherwise they were a bit droopy. Next time I’ll take the time to find some netting to do the stuffing– it would hold its shape better.

q-hearts-sleeve

I finished off the costume with a tiara from eBay and a pair of black satin gloves. Hint: do not balance your tiara on your head just to see how it will look, then forget it’s not pinned on and bend over to look at something– it will fall off, clang on the floor, and lose half a dozen tiny rhinestones which you will then have to locate and glue back in. (sigh)

Stay tuned for pictures of the finished costume!

The Grey Lady, Part IV: The Lost Diadem of Ravenclaw

GL diadem stone

To take a brief break from sewing, the first accessory I purchased for this outfit was a no-brainer*: the Lost Diadem of Ravenclaw. I’d considered making my own without being shackled to the movie version, but let’s face it, the movie version is actually reasonably attractive and at $9.99 for an eBay knockoff there’s no way I’d be able to make something equally nice for as little money. So I ordered it, and figured that I could remove some of the larger dangly jewels if they turned out to look too hokey.

Unfortunately, when it arrived there were several issues– first and foremost, it was angled so sharply that it was impossible to wear– seriously, there was a clear inch of space between my head and the curve of the diadem, and there was no way to bend it to fit. Also, despite the side pieces being too short to wear as an actual headband, there were no loops or anything else to pin the diadem to the head– so even if it had been angled properly it would’ve fallen off easily. Clearly, something had to be done. Continue reading

Vanessa/Ursula Costume, Finally Done!

It’s finished! Here are pictures from just before I packed it up in the world’s largest garment bag to take to Anime Boston:

ursula done toy

ursula done glance ursula done mirror

Please ignore the mess in the background– I’ll get better shots when I go to Anime Boston next week. I really need to learn the best angles to shoot this outfit from so the tentacles show to good advantage.

Also, you know what’s scary? I have Tammy-Faye Baker levels of eye makeup on in these pictures– the biggest false eyelashes I could find, additional false lashes on the lower lid, black eyeliner, white eyeliner, the works. But it’s still not all that scary in pictures. And frighteningly enough, after about an hour of wearing the stuff it ceased to startle me in the mirror. This must be how people get used to wearing it every day…

Vanessa/Ursula Costume, Part IX: The Accessories

Ursula tiara movieursula movie shell

So, back to costumes… the dress is finally done, but there’s still plenty to do before the costume is completely finished.

First up is making the veil and headpiece. The veil in the movie actually looks to be opaque, but I don’t like the look of that so I ordered a 6′ long, single layer veil in ivory tulle on eBay for just under $6 (including shipping, which cost more than the veil). It came wrinkled, but nothing that a session in a steamy bathroom didn’t cure. It ended up being a hell of a lot longer than 6′, though, so I trimmed it to about 12″ off of the floor. This way it won’t get tangled in the tentacles, and no one will step on it.

The movie scenes showed that the headpiece was the same color as the ruffles on the dress, so I cut two tiara shapes out of a manila folder, one of them with tabs on the bottom edge (more on that later)– and covered them in fabric. To do that, I painted a thin layer of glue onto each cardstock piece, then smoothed the fabric over them. Once they were dry, I cut the fabric about 1/2″ from the edge of the cardstock (clipping the curves), folded it over, and glued it down on each piece. Then I sandwiched the pieces together, fabric on the outside, with hot glue. I also inserted two twist ties between the layers to help with stiffness, though in retrospect that wasn’t necessary.

vanessa veil copy

I folded the tabs at a right angle, bending the twist ties to help keep things in place, and used hot glue to attach them to the inside surface of a black headband so the tiara sat directly in front of it. I’d originally planned on gluing the tabs on top of the headband, but the extra 1/4″ in height makes the tiara sit unnaturally high on my head (and I don’t have poofy Disney princess hair to make it work), so I’m going with this instead. Then I just hot-glued the veil to the headband, right behind the tiara.

(UPDATE 3/25/15: after I tried on the veil I decided it wasn’t draping as well as it could have, so I stitched a 1/2″ strip of white horsehair braid into the hem to give it some body. Looks much better now.)

My original Ursula costume used a cardboard cutout painted to look like a golden shell for Ursula’s necklace, but for this costume I wanted to go with the real thing, so I sourced it out to Etsy. The shell came painted gold, and I touched up the shadows a bit with darker paint just to make them more visible from a distance. Here’s the before and after:

vanessa shell painted

It looks great and probably doesn’t cost much more than I’d have paid anyway for supplies. I did consider trying to find one of those recordable mini-chips that they put into greeting cards to record Ariel’s voice and play it back at appropriate times, but the chips are surprisingly bulky and wouldn’t fit inside the shell.

Finally, while there’s nothing like this in the movie I do need a bag to keep things in at the convention, particularly since I’ve had to forego pockets in the dress. I like to make bags from leftover dress fabric (helps the bag blend in to the skirt during photos), but my dress disaster took up almost all of my extra fabric in the repair. Luckily I put my patchworking skills (already honed from earlier) to good use on the scraps and managed to whip up a reasonably-sized drawstring bag to carry with me. It’s not gorgeous or anything, but it’ll do.

ursula bag

Hey, does this mean that I’m done? Like, DONE done? And with two weeks to spare! Amazing! Pictures of the whole outfit put together coming up soon…

Tips:

1. If you’re going to make something to attach to a headband, make sure that you cut it to fit your head, not just the band. Since the headband will be bent into a different shape when you’re wearing it, just tracing it as-is onto paper won’t give you the right curve.

2. When gluing fabric to things I like to use tacky glue rather than white glue. It’s stickier and less likely to bleed through. Also, I brush the glue onto the non-fabric surface and let it sit for a while to increase the stickiness before smoothing the fabric onto it. If you don’t do this step, the glue just soaks into the fabric and nothing sticks.

3. On the other hand, when you need a fast, strong bond, hot glue is definitely the way to go. I used it for all of the structural parts of the tiara. The only reason I didn’t use it for the fabric was because it’s too dimensional to get a smooth surface.