To attach the skirts to the bodice (the last major construction step) I worked with each skirt separately– the underskirt was narrower than the overskirt, and I wanted to pleat them separately so they’d flow more gracefully when I moved. I only achieved limited success with that due to the stiffness of the hem trims (as noted earlier), but I did the best I could.
I pinned and basted each skirt to the bodice before machine-stitching the final waist seam (praying I wouldn’t screw anything up), and whipstitched the bodice lining over the seam allowance so the inside would be neat.
So like I said earlier, I wanted to take full advantage of the beautiful embroidered sections of the sari when constructing my gown. As you’ll read below, this had its ups and downs…
First I removed the pallu of the sari (I admit I cringed at the first cut of the shears– what if I screwed it up?) and cut it lengthwise to make two even panels. I immediately ran a zig-zag stitch along the cut edges to prevent fraying. (I actually did this every time I cut an edge that wouldn’t be encased in fabric) The panels aren’t exactly the same– the design is upside-down on one piece because the pallu wasn’t vertically symmetrical, so when I flipped the top half over to act as the hem it didn’t quite match. I figure no one will notice, since that part will be down near my ankles anyway.
I made an underskirt out of dark blue cotton voile, making it only as wide as the pallu pieces at the bottom. I tapered the front panel slightly, but cut the back panel as a rectangle so I could do some– but not too much– pleating in the back. The goal was to reduce bulk at the waistline, but I needed at least *some* pleating in back so both layers of the skirt would fall into nice folds.
For the front panel of the overskirt I cut two 34″ skirt pieces from the part of the sari directly above the pallu– like I did with the cotton Regency sari gown, I wanted to use the side borders to form a double-width embellishment down the center front of the skirt. (Well, almost double-width– I decided it looked better if I omitted the border edges down the center) Additionally, the borders on this portion of the sari weren’t just brocade, they were also embellished with beads, so I wanted them front and center.* Once they were cut out I stitched them together to form a trapezoidal front skirt panel, and attached another long piece of border to the straight bottom edge. This would prove to be a mistake.
The period spanning the late 1890s and early 1900s has always been my favorite when it comes to evening wear. You’ve got the slim waist, slightly fitted hips, and the elegant swoosh to the bottom of the skirt, which all combine for a breathtaking silhouette. Plus, you’ve got gorgeous fabrics and trimming, which can run the gamut from embroidery to lace to faux flowers to beading… the possibilities are endless. Which is why, when I heard about a Victorian-themed dance weekend in my area, I knew I’d have to make something for it.
I browsed through Pinterest looking for inspiration, concluding (as I’d always known I would) that the spectacular gowns by Charles Frederick Worth were what I’d eventually end up mimicking. Just look at the gorgeousness!
After I’d finished drooling, I decided that I’d want to do some kind of embroidered embellishment to go down the front of the entire gown, much like the butterflies you see above. And because I always have to make things difficult for myself, I eschewed the idea of embroidered roses (which I could’ve done using pre-made appliques) and decided on wisteria. I was really inspired by this Japanese fabric:
So, the gown will be purple, with trailing wisteria blossoms and leaves, possibly some flowing water lines at the hem. Simple, right? Famous last words…